Audiovox Cable for Navigation Box CS9100

This additional cable connects the navigation box CS9100 to Audiovox (Jensen) touch screen AV receivers, allowing you to transmit the image (RGB) and sound (mono) from the CS9100 navigation box to the AV receiver and run the navigation system through a touch screen interface.

Supported Audiovox (Jensen) Multimedia Receivers:

• VM9022 (Press and hold the PIP button)
• VM9022HD (Press and hold the PIP button)
• VM9312HD (Press and hold the WIDE button)
• VM9212N (Press and hold the WIDE button)
• VM9213 (Press and hold the WIDE button)
• UV9 (Press and hold the WIDE button)
• VM9223 (Press and hold the PIC button)
• VM9312HD (Press and hold the WIDE button)
• VM9313 (Press and hold the DISP button)
• VM9412 (Press and hold the DISP button)
• VM9413 (Press and hold the NAV button
• VM9423 (Press and hold the NAV button)
• VM9512 (Press and hold the DISP button)
• VM9512HD (Press and hold the DISP button)
• AMM10N (Press and hold the DISP button)
• AMM12N (Press and hold the DISP button)
• VME 9022 TS (Press and hold the PIP button)
• VME 9122 TS
• VME 9309 TS (Press the WIDE/NAV button)
• VME 9312 TS (Press and hold the WIDE button)
• VME 9314 TS (Press the WIDE/NAV button)
• VME 9512 TS

Before you connect CS9100 to a Audiovox (Jensen) multimedia receiver, make sure to activate a corresponding protocol. For this, hook up CS9100 to a power source and connect it to a TV or any other video signal receiver through a composite output. Then configure CS9100 using the control panel: